This should resolve the "no UEFI Firmware Settings" error. Put the computer cover back on, plug in your computer, and then power it on. To enter the UEFI or legacy BIOS during boot, use these steps: Press the Power button.Move the CMOS jumpers back to their original pins.From there, wait for about 15 seconds and then put it back on. Next, remove the CMOS battery from its slot.In this case, temporarily plug the jumpers on both pins. If your motherboard has only two pins, the jumpers will likely be plugged into one pin. If the CMOS jumpers are on the first and second pins, temporarily shift them to the second and third pins.Now, let's check out how to clear the CMOS settings: Use 'FPT -BIOS -D BIOSDUMP.BIN' 2.Open your dump with HEX editor and search C1 8A 00 0C 10(Most 6/7th) or C7 8A 00 0C 10(Most old ASUS 100 series) or C2 8A 00 0C 10(Most Gigabyte 300 series) or 6A 10 53 56(Most ECS and MSI Laptop 300 series) 3.You will find only one HEX pattern match. The jumpers will be located on only two of the three pins. Usually, you’d find three pins where the CMOS jumpers are located. The battery should be somewhere near this reading. To easily locate the CMOS battery, look for a “ CLR CMOS” reading on the motherboard.Remove the bottom cover of your PC and look for the CMOS battery and jumpers on the motherboard.Turn off your computer and unplug it from the power source.This will help restore your computer to its default BIOS settings.īut before clearing the CMOS settings, you have to locate the CMOS battery and jumpers through these steps: Are you still struggling to resolve the "No UEFI Firmware Settings Windows 10" issue? As a last resort, you can reset the CMOS settings from your PC’s motherboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |